Journals Information
Universal Journal of Mechanical Engineering Vol. 2(2), pp. 49 - 54
DOI: 10.13189/ujme.2014.020203
Reprint (PDF) (652Kb)
Investigation of Machinability Tests for Brass Alloy
Hana Pechov谩 1,*, V谩clav Koutn媒 1, Ji艡铆 Faltus 2
1 Czech Technical University in Prague, Faculty of Mechanical Engineering, 166 07 Praha 6, Technick谩 4, Czech Republic, Europe
2 V脷K Panensk茅 B艡e啪any, Panensk茅 B艡e啪any, 25070, Praha 鈥� V媒chod, Czech Republic, Europe
ABSTRACT
The Brasses are copper alloys. The main element is zinc brass. The most widespread are Cu and Zn binary alloys with different contents of zinc. Binary brass make up a relatively large group of copper alloys in which zinc content varies from 2.5 to approximately 49 %. In addition, there brass, which, besides zinc has other elements. These alloying elements give the brass its material properties. According to the zinc content is divided into low, medium and high percentage of zinc brass.
KEYWORDS
Brass, Lathe, Drilling, Constant Yoke Force, Turning, Chips
Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Hana Pechov谩 , V谩clav Koutn媒 , Ji艡铆 Faltus , "Investigation of Machinability Tests for Brass Alloy," Universal Journal of Mechanical Engineering, Vol. 2, No. 2, pp. 49 - 54, 2014. DOI: 10.13189/ujme.2014.020203.
(b). APA Format:
Hana Pechov谩 , V谩clav Koutn媒 , Ji艡铆 Faltus (2014). Investigation of Machinability Tests for Brass Alloy. Universal Journal of Mechanical Engineering, 2(2), 49 - 54. DOI: 10.13189/ujme.2014.020203.