Journals Information
Universal Journal of Mechanical Engineering Vol. 3(1), pp. 7 - 11
DOI: 10.13189/ujme.2015.030102
Reprint (PDF) (305Kb)
Processing and Characterization of Glass-epoxy Composites Filled with Linz-donawitz (LD) Slag
Pravat Ranjan Pati *, Alok Satapathy
Department of Mechanical Engineering, National Institute of Technology, Rourkela, India
ABSTRACT
Linz-Donawitz (LD) slag a major solid waste generated in huge quantities during steel making. It comes from slag formers such as burned lime/dolomite and from oxidizing of silica, iron etc. while refining the iron into steel in the LD furnace. Although a number of ways for its utilization have been suggested, its potential as a filler material in polymeric matrices has not yet been explored. The present work reports the possible use of this waste in glass fiber reinforced epoxy composites as a filler material. Hybrid composites consisting of bi-directional E-glass-fiber reinforced epoxy filled with different LD slag content (0, 7.5, 15, 22.5 wt%) are prepared by simple hand lay-up technique. The composites are characterized in regard to their density, porosity, micro-hardness and strength properties. X-ray diffractography is carried out in order to ascertain the various phases present in LDS. This work shows that LD slag, in spite of being a waste, possesses fairly good filler characteristics as it modifies the strength properties and improves the composite micro-hardness of the polymeric resin.
KEYWORDS
Characterization, Glass-epoxy Composites, LD Slag, Waste Utilization
Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Pravat Ranjan Pati , Alok Satapathy , "Processing and Characterization of Glass-epoxy Composites Filled with Linz-donawitz (LD) Slag," Universal Journal of Mechanical Engineering, Vol. 3, No. 1, pp. 7 - 11, 2015. DOI: 10.13189/ujme.2015.030102.
(b). APA Format:
Pravat Ranjan Pati , Alok Satapathy (2015). Processing and Characterization of Glass-epoxy Composites Filled with Linz-donawitz (LD) Slag. Universal Journal of Mechanical Engineering, 3(1), 7 - 11. DOI: 10.13189/ujme.2015.030102.