Journals Information
Manufacturing Science and Technology(CEASE PUBLICATION) Vol. 3(5), pp. 197 - 203
DOI: 10.13189/mst.2015.030501
Reprint (PDF) (2232Kb)
Casting of Clad Strip by a Vertical Type Twin Roll Caster
Toshio Haga 1,*, Hisaki Watari 2
1 Department of Mechanical Engineering, Osaka Institute of Technology, Japan
2 Tokyo Denki University, Japan
ABSTRACT
A sound three-layer clad strip of 4045, 3003, and 4045 was cast by a vertical type tandem twin roll caster. However, a sound three-layer clad strip of 5182, 3003, and 5182 could not be cast. The 5182 overlay strip did not bond to the 3003 base strip. The latent heat of Si and Mg are 1787 kJ/kg and 230 kJ/kg, respectively. The latent heat affected the rise in temperature of the base strip. The 3003 was not heated up to a temperature suitable for bonding with the 5182 overlay strip. A sound two-layer clad strip of 3003 and 5182 could be cast by a twin roll caster equipped with a scraper. The temperature of the 3003 was near the solidus line, and sound bonding occurred.
KEYWORDS
Clad Strip, Twin Roll Caster, Bonding, Bonding Interface, Continuous Casting
Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Toshio Haga , Hisaki Watari , "Casting of Clad Strip by a Vertical Type Twin Roll Caster," Manufacturing Science and Technology(CEASE PUBLICATION), Vol. 3, No. 5, pp. 197 - 203, 2015. DOI: 10.13189/mst.2015.030501.
(b). APA Format:
Toshio Haga , Hisaki Watari (2015). Casting of Clad Strip by a Vertical Type Twin Roll Caster. Manufacturing Science and Technology(CEASE PUBLICATION), 3(5), 197 - 203. DOI: 10.13189/mst.2015.030501.