Journals Information
Universal Journal of Electrical and Electronic Engineering Vol. 6(2B), pp. 1 - 6
DOI: 10.13189/ujeee.2019.061401
Reprint (PDF) (284Kb)
Identification the Potential Causes of Stopline in Electrolytic Tinning Line Using Multi Attribute Failure Mode Analysis
R. Ekawati *, N. Wahyuni , R. Annisa
Department of Industrial Engineering, University of Sultan Ageng Tirtayasa, Cilegon, Indonesia
ABSTRACT
PT. XYZ often suffers stopline in its production process of producing tin plate type coil in Electrolytic Tinning Line (ETL) machine which is used nonstop. The purpose of this research is identifying cause of stopline and determining the most potential cause of stopline using Multi Attribute Failure Mode Analysis (MAFMA). MAFMA itself is a combination method between FMEA and AHP. The result shows the causes of stopline are damaged bearing, broken shaft, not fitted construction, damaged rubber lining in sidewall, many tin particles in roll, torn roll, groove roll and bubble roll. The most potential cause is damaged bearing by weight of 0.172.
KEYWORDS
MAFMA, AHP, Stopline
Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] R. Ekawati , N. Wahyuni , R. Annisa , "Identification the Potential Causes of Stopline in Electrolytic Tinning Line Using Multi Attribute Failure Mode Analysis," Universal Journal of Electrical and Electronic Engineering, Vol. 6, No. 2B, pp. 1 - 6, 2019. DOI: 10.13189/ujeee.2019.061401.
(b). APA Format:
R. Ekawati , N. Wahyuni , R. Annisa (2019). Identification the Potential Causes of Stopline in Electrolytic Tinning Line Using Multi Attribute Failure Mode Analysis. Universal Journal of Electrical and Electronic Engineering, 6(2B), 1 - 6. DOI: 10.13189/ujeee.2019.061401.